"We offer new support options and therefor the forums are now in read-only mode! Please check out our Support Center for more information." - Vuforia Engine Team

ATG Failed with Leica E57 file

By adilaghayev on Thu, 05/06/2021 - 10:47

Hi,

I am trying to create an area target from a Leica BLK360 scan. I've followed all the steps successfully and managed to create a proper Area Target from a smaller sample of the scan. When I try to create an area target from the full 1.5 GB E57 file, the Area Target Generator fails with no error message. Please, see the screenshot for details. It fails after it generates occlusion mesh.

Any idea what could be the problem? There is enough empty storage on disk (60GB) and the previous, partial model worked just fine.

Hi,

Could you please try with the 9.8.8 ATG? we just solved an issue: https://developer.vuforia.com/forum/area-targets/resolved-known-issue-985-area-target-generator-using-e57

If the generation also fails with 9.8.8, please provide us the entire error log.

adilaghayev

Sat, 05/08/2021 - 10:04

Permalink

Thank you!

The problem was resolved once I reinstalled ATG with version 9.8.8.

Attachment
Inkedatgfail_LI.jpg