Log in or register to post comments

Vuforia Multi-Target Data Set is not working

April 20, 2013 - 10:53am #1

Hi,

I downloaded the Vuforia sample Multi-target unity package from the link below.
https://developer.vuforia.com/resources/sample-apps/multi-target-sample-app

Then I fisrt loaded the sample app and I build the adroid apk and installed it in my phone. Its working 100%. But when I load my own data set its not working. 
I just replaced the existing MultiTarget data set with my data set and then I activate in ARCamera. But when I build and load the app, nothing happens... its not detecting the Box. 

My box dimensions are width = 300, height = 150, length = 300, When I load the images to the box it shows 3 stars for Augmentable rate. Herewith I have attach my data set as well.

Is there anything I need to setup other than I have mention above ? can anyone please help me on this to figure out the problem. 
Looking forward for a early reply. Thanks in advance.
Amal.

 

AttachmentSize
Binary Data bytes

Vuforia Multi-Target Data Set is not working

November 30, 2013 - 5:09am #5

Hi,

 

I just experience the same problem. I downloaded my own dataset for 3d model (box) tracking activated it in the ar camera and selected it in the inspector but still no luck? All rated at least 3 stars. There is one thing the sides of the box are vertical images as I attached but it sees it horizontal and scales it to vertical. Can it be the problem?

Vuforia Multi-Target Data Set is not working

April 21, 2013 - 8:24am #4

Ok, good to hear you solved it!

Vuforia Multi-Target Data Set is not working

April 21, 2013 - 7:29am #3

Hi, 

Yes, I have already selected the dataset and target name in the MultiTargetBehaviour script (using the inspector). Finally I found the problem. One of the interface in the box had a low star rating. That was the issue and once I replaced it with another picture, it started working. :)

Thank you very much for the support. Appriciate a lot. :)

Vuforia Multi-Target Data Set is not working

April 20, 2013 - 1:20pm #2

Hi, have you also selected your dataset and target name in your MultiTargetBehaviour script (using the inspector) ?

If the star rating is OK as you say, then that's the only issue that I can think of.

 

Log in or register to post comments