Log in or register to post comments

Error in area target generator

September 21, 2022 - 11:00pm #1

Error opening E57 file with Area Target Generator

please tell me the reason

E57 processing: Reading of the E57 file failed. The path to the E57 file might be wrong or the file might be corrupted. Failure was: "size in file header not same as actual (E57_ERROR_BAD_FILE_LENGTH)"

E57 processing: Reading of the E57 file failed. The path to the E57 file might be wrong or the file might be corrupted. Failure was: "E57 element path well formed but not defined (E57_ERROR_PATH_UNDEFINED)"

Error in area target generator

October 2, 2022 - 7:00am #3

hi,

Please note that the Area Target Generator is not accepting arbitrary E57 input data. Make sure to use one of the supported scanners as listed here: https://library.vuforia.com/environments/area-targets#prerequisites and process the data according to our step-by-step instructions on the below linked pages, depending on the scanner vendor:

Best,

Vuforia Team

Error in area target generator

October 2, 2022 - 12:33am #2

Under "Advanced" of the Area Target Behavior Script properties, try toggling the Mesh Collider on/off. And try clicking off the Area Target in the scene view, and then clicking on it again

Log in or register to post comments