Log in or register to post comments

Hololens2 MRTK Vuforia fails to init on device

January 17, 2021 - 8:50am #1

Hello,

 

So I have an MRTK 2.5.3 and Unity 2019.4.13f1  project running Vuforia 9.6.4 and utilizing "Image Targets" if that matters. In the unity play the project works fine

however once made into an Appx and put onto the Hololens2 it gives these errors from the in game terminal: http://prntscr.com/wob4dz

So the initialization completely fails. I have tried googling very hard but I cannot find any good results.

Perhaps the closest thing could be this https://developer.vuforia.com/forum/hololens/hololens-2-unity-20194-vuforia-94

however I am not sure how to apply the fix from that. If anyone could assist me that would be amazing. It is an old project made half a year ago which I am attempting to edit for my master thesis (unity not the focus) so I am not even the original creator and do not understand Vuforia that well. What should I focus on?

This fails completely at the beginning so this is how my first two scenes look like if it helps: http://prntscr.com/x19lo5

Once again I'm looking for some good advice and guidance since I have been wasting too much time on this issue.

 

Thanks in advance!

 

Log in or register to post comments