By shoshoda
on Wed, 12/02/2020 - 09:13
Hi,
We are using Hololens 2.
We want to display an object on a qrcode. With a camera it's working perfectly but when we put our build on Hololens 2 the object was not on our qr code but it is offset on the left or right.
Do you have any ideas about this problem ?
Thanks.
I have the same issue, even
I have the same issue, even after the 9.6.3 update. In the editor it works perfectly, on the Hololens 2 it has a really visible offset
Hi @shoshoda @Huszky,
Hi @shoshoda @Huszky,
I'll try this today
I'll try this today
I attached the image i see
I attached the image i see with the Hololens 2. The size is set to 0.115 and the size of the printed QR Code s 11.5cm.
On the image where my right hand finger is is where I see the Button floating. It's approximately 5-10 cm above the printed image
Hi @ Huszky,
Hi @ Huszky,
From our experience, there are several factors that can cause an augmentation to be offset, including:
Thanks for the advice, I'll
Thanks for the advice, I'll see if I can improve my situation with calibrations. I'll write back tomorrow.