Log in or register to post comments

conical paper model / cup

September 29, 2019 - 12:28pm #1

Can the image target for a cup be inside the cup? I can see the guidelines are given for labels and images outside the cup, but my project needs an image target  on the inside. 

conical paper model / cup

October 2, 2019 - 5:44am #2

Hi

I switched inside out the cylinder Unity samples and the detection/tracking worked ok-ish. The issue that I found is the reduced visibility inside the cylinder will represent an issue in detecting the Image Target.

I believe that you will need to test your scenario through to see if this would be a viable solution.

Thank you.

Vuforia Engine Support

Log in or register to post comments