By TeiLouis
on Fri, 06/04/2021 - 15:34
Hello,
i created a Model Target for HoloLens2. The Model Target works fine in Unity play mode (watch picture 1 and 2) but on HoloLens 2 there is everytime a huge displacement (watch picture 3). I used the lastest Vuforia SDK 9.8.8.
(I tried almost 15 different setups in the Model Target Generator for my CAD-Model but everytime i get similar displacements)
How can i solve this problem?
Best regards,
Louis
Hello ,
Hello ,
did you check if the model target is generated with the correct units // my impression inch - cm scale