Topic locked

Model creator failed to create model

January 18, 2022 - 2:04pm #1

I have a scanned 3D model in obj format. I load it into the latest 10.3 Model creator and everything is all green lights across the top. I click created model target and I just get a pop up that says it failed. No more info and I can't find any logs.  However in my old 8.x version of model creator it creates the model just fine.  Any advice on where I could look to figure out this failure? 

 

I tried to attach my obj file but the forum says:

The file inside_breakera.zip could not be saved, because it exceeds 0 bytes, the maximum allowed size for uploads.

    The file in the field was unable to be uploaded.

 

Thank you.

Model creator failed to create model

January 20, 2022 - 8:40am #2

Hello,

Can you upload the file that fails to a sharing service and post the link here? This would give us the best opportunity to evaluate the issue.

Kind regards,

Dave Downing

Technical Support

Topic locked