Log in or register to post comments

Object Offset with HoloLens

December 13, 2016 - 1:50am #1

Hello everyone,

I'm experimenting with Vuforia with our companys HoloLens for 4 days now and I'm really glad to have the possibility to have object recognition on HoloLens now.

Unfortnunately, I'm always experiencing some offset of the virtual to the recognized object. It seems to depend on the scale of the bounding box. With 0.05x0.05x0.05 it is approximately about 0.5x0.5x0.5 meters off. At testing with the object scanner, the augmentation is and stays where it should be.

Since I haven't found anyone with the same problem, I'm probably doing something wrong even if I followed all the Getting started instructions. 

Does anyone have an idea, what could cause the problem?

 

Thank you very much!

 

Object Offset with HoloLens

December 13, 2016 - 2:41pm #2

Hello,

Not sure of the source of the problem, but here is a solution posted in the HoloLens forum:

https://developer.vuforia.com/forum/hololens/objecttarget-placement

Thanks.

Log in or register to post comments