"We offer new support options and therefor the forums are now in read-only mode! Please check out our Support Center for more information." - Vuforia Engine Team

Object Offset with HoloLens

By GregorT on Tue, 12/13/2016 - 09:50

Hello everyone,

I'm experimenting with Vuforia with our companys HoloLens for 4 days now and I'm really glad to have the possibility to have object recognition on HoloLens now.

Unfortnunately, I'm always experiencing some offset of the virtual to the recognized object. It seems to depend on the scale of the bounding box. With 0.05x0.05x0.05 it is approximately about 0.5x0.5x0.5 meters off. At testing with the object scanner, the augmentation is and stays where it should be.

Since I haven't found anyone with the same problem, I'm probably doing something wrong even if I followed all the Getting started instructions.

Does anyone have an idea, what could cause the problem?

Thank you very much!

Hello,

Not sure of the source of the problem, but here is a solution posted in the HoloLens forum:

https://developer.vuforia.com/forum/hololens/objecttarget-placement

Thanks.