By aurorej
on Fri, 04/07/2017 - 13:30
Hi
I try to use the scanner App to be able to do object recognition with small toys (30x30x40mm)
But when I do it I notice that some points define during the scan refers the top of the white arrow on the orthonormal coordinate system printed on the paper.
Is it possible to avoid that ?
Can I remove those point from the generated .od ?
When I test the toy is only detected on the printed scan marker :(
Is there a minimal size require for the object to ensure that the scanner will be done correctly ?
Thanks
Hello,
Hello,
The most important aspect of object recognition is the number of keypoints extracted during the scanning process.
Is this a commercially available toy? If so, please provide a link as I'd like to replicate the workflow.
Hi
Hi
Ok so the object can be small the scanner application is ok with that ?
I try with bigger object and it works better that's why I ask...
Hello,
Hello,
Thanks for the response. I've ordered the same toy so that I can do some experimentation with it.
Thanks.
Hello,
Hello,
I received the toy this week and performed the following actions: