- Sort Posts
- 6 replies
- Last post
Re: 3d model doesn`t appear
February 13, 2012 - 11:27am #6
Re: 3d model doesn`t appear
December 14, 2011 - 8:01am #4
Just make sure the model is a reasonable size compared to the image target.
Is this model much bigger/smaller than ones you've used in the past? Have you increased/decreased the scale of your image target by a large amount? If so, you might need to adjust the near/far parameters on the ARCamera.
Try dropping a "good" model back on your target and see if it still works.
- Kim
Re: 3d model doesn`t appear
December 14, 2011 - 6:44am #2
It should be mentioned in the 1.5 beta documentation (available as a downloadable pdf on the portal). Once 1.5 is out of beta the online documentation will be updated as well.
- Kim