Log in or register to post comments

UCS

February 21, 2013 - 6:44am #1

 

I want to now if its possible to put more than one image taget, them allow me to go through the images with my 3D.obj, even when one of image target is out of view.

Similar to UCS. but not with UCS.

UCS

February 25, 2013 - 12:36am #4

It should be possible to do what you describe with UCS by elecman; in general you just need to add your 3D model into the scene (in the Unity editor), following the instructions in the PDF manual of the project:

http://forum.unity3d.com/threads/108256-Unified-Coordinate-System-for-String-and-QCAR

(have a look at the manual). 

You may also want to send a PM to elecman directly.

UCS

February 24, 2013 - 5:01am #3

http://gringofxs.webs.com/p1.jpg

http://gringofxs.webs.com/p2.jpg

Here is what im saying.

I now how to do that with vuforia image target, but i need to have more image target to get a bigger fieldsize.
The 3D model I already have it.

UCS

February 22, 2013 - 1:09am #2

Hi, UCS is probably a very good start; presumably you could take inspiration from that implementation and adjust it to your specific use case;

on the other hand, it's not fully clear what effect you would like to achieve (and how exactly it differs from UCS); could you explain it a bit more in detail ?

Log in or register to post comments